Key Points

AntennaCraft HBU55 installation

July. 4. 2010 by lawnz –  Category: Electronics, Technology (1 Comment)

Pictures show how AntennaCraft HBU55 looks, it was not hard to piece together
antenna parts, it was hard to drill the holes on the chimney, I bought the side mount
kit from Radio Shack where I got the antenna, I got a small package with couple of
special screws for concrete and the drilling bit (included) from Walmart, I drilled the
pilot holes, one hole I drilled was a little too big, I put some paper inside the hole,
then put the screws in to secure the mounting kit, after installation, make sure aim
it to the transmitter on the mountain. or go check tvfool.com to enter your
address to find out the directions of channels, the cables runs about 150 feet
without any amplifier, singal is very stable, much better than those small antennas,
I get all the free major channels in bay area CA.

I recommend this antenna to anyone like to play and save money, there is
no contract to be signed with AntennaCraft HBU55:)